on or plugged in.
• This appliance is equipped with a safety thermostat. In
the event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the dryer to the ‘0’ position, unplug
and allow to cool for 10 minutes. Before use, ensure
the rear filter is clear of hair and other debris. Plug in
and switch on. If the appliance continues to overheat
discontinue use immediately, switch off and unplug,
and contact the Conair Customer Care Line (refer to
‘UK After Sales Service’ section for further information).
• Take care that the air vents do not become blocked
when in use. Ensure the rear filter is clear of hair and
other debris before use.
• During use, do not place the appliance on any heat
sensitive surface.
• Take care to avoid the hot surface of the appliance
coming into direct contact with the skin, in particular
the ears, eyes, face and neck.
• This appliance should not be used by adults whose
reduced physical, sensory or mental capabilities, or
whose lack of experience and knowledge, might cause
a hazard, unless they have been correctly instructed to
understand the safe use and hazards involved and are
adequately supervised.
• Allow the appliance to cool before storing away.
• After use do not coil the lead around the appliance as
this may cause damage to the lead. Instead coil the
lead loosely by the side of the appliance.
