BaByliss 7758U, Manual

WARNING! 

The clipper is for use only on the head. Never use the clipper 

on the face or any other area of the body.

Clipping

• Attach the comb guide length of your choice. Grade 1 = 3mm, Grade 2 =  
  6mm, Grade 3 = 9.5mm, Grade 4 = 13 mm.
• Switch on the clipper using the on/off sliding switch located on top of the  
  clipper. The blades will start to move and the green LED will illuminate.
• Starting at the nape of the neck, hold the clipper with the teeth of the  
  clipper pointing upwards and the comb guide flat on the head. Slowly  
  move the clipper upwards, through the hair, and towards the front of the  
  head in a forward sweeping motion. Once at the front of the head, engage  
  the opposite blade in a backward sweeping motion to move from the front  
  of the head, back to the nape of the neck. 
• Continue with this sweeping motion, running from the nape of the neck  
  to the front of the head until you reach an even length all over.
• To tidy longer hairs around the ears and neckline, simply remove the  
  comb guide and use the blade for neatening edges and shaping 

 sideburns.
• Only apply gentle pressure. Never force the clipper, if resistance is  
  experienced lift clipper away from the head, empty hair from the clipper  
  and resume clipping.
• If using on areas where there are folds of skin, ensure the skin is stretched  
  taught prior to cutting hair in this area.
• If you experience any discomfort stop using immediately.
•  If you require a grade 0 (0.5mm) cut, the clipper can be used without a comb  
  guide attached.

Please Note:

 When you first begin cutting your hair, you may notice that 

some hair is being cut, while others are left long. This is perfectly normal, 
especially if cutting slightly longer hair because hair grows in many different 
directions. Continue cutting in a back and forth sweeping motion until all 
the hair is cut to an even length.