45
EN
3.2. Carrying out a test with Homelight®
Carry out a test with Homelight® 48 hours before the
first use.
1. Plug the adapter cord into the socket on the Homelight®
device
(which is located on its handle) (FIG. 1).
2. Plug the other end of the adapter into a power socket.
> The ON/OFF button turns on and is orange in colour
(FIG. 2).
3. Switch on the appliance by pressing the ON-OFF button (FIG. 3).
> The ON-OFF button turns green.
> T he power level 1 LED indicator is on. Level 1 is
programmed by default when the appliance is switched
on (FIG. 4).
4. Place the appliance Skin Sensor on the area of skin where you wish
to perform the test (we recommend a leg) (FIG. 5)
> The intensity level LED indicator(s) switch on and flash,
showing that the appliance has successfully detected the
phototype of the area of skin to be depilated and adjusted
the power level automatically (FIG. 6).
5. Press once on the trigger to confirm (FIG. 7)
> The intensity level LED indicator(s) stop flashing (FIG. 8).
6.
Position the application surface on the area of skin detected and
keep the application surface still, in position, to ensure total contact.
> The Ready LED flashes when the appliance is correctly
positioned on the skin and ready to release a light pulse
(FIG. 9)
7. Press on the trigger to release a light pulse onto the skin (FIG. 10).
N.B.: You may feel a slight hot sensation and tingling.
8. Move the application surface to another area of skin and press the
trigger to release another light pulse. Take care not to overlay the
light pulses.
G960E IB 1-2.indd 45
14/07/2016 1:25 PM
