6mm, Grade 3 = 9.5mm, Grade 4 = 13 mm.
• Switch on the clipper using the on/off sliding switch located on top of the
clipper. The blades will start to move and the green LED will illuminate.
• Starting at the nape of the neck, hold the clipper with the teeth of the
clipper pointing upwards and the comb guide flat on the head. Slowly
move the clipper upwards, through the hair, and towards the front of the
head in a forward sweeping motion. Once at the front of the head, engage
the opposite blade in a backward sweeping motion to move from the front
of the head, back to the nape of the neck.
• Continue with this sweeping motion, running from the nape of the neck
to the front of the head until you reach an even length all over.
• To tidy longer hairs around the ears and neckline, simply remove the
comb guide and use the blade for neatening edges and shaping
sideburns.
• Only apply gentle pressure. Never force the clipper– if resistance is
experienced lift clipper away from the head, empty hair from the clipper
and resume clipping.
• If using on areas where there are folds of skin, ensure the skin is stretched
taught prior to cutting hair in this area.
• If you experience any discomfort stop using immediately.
• If you require a grade 0 cut, the clipper can be used without a comb
guide attached.
Please Note:
When you first being cutting your hair, you may notice that
some hair is being cut, while others are left long. This is perfectly normal,
especially if cutting slightly longer hair because hair grows in many different
directions. Continue cutting in a back and forth sweeping motion until all
the hair is cut to an even length.
Removing the blades
• The blades can be removed to aid cleaning.
• To remove the blades, hold the handle by two hands,place your two
thumbs underneath the blades and push the blades away from the
handle (Fig. 1).
• Gently blow away any hair trapped beneath the blades.
• The blades can be rinsed under the tap. After rinsing, the blades may
need to be oiled. See oiling instructions below.
• Be sure the blades are dry before reattaching to the clipper body.