if the appliance is switched off. For additional protection
the installation of a residual current device RCD) with a
rated residual operating current not exceeding 30mA is
advisable in the electrical circuit supplying the bathroom.
Ask your installer for advice.
WARNING!
Do not use this appliance near water
contained in basins, bathtubs or other vessels.
• Do not use this appliance in the bathroom.
• Do not immerse the appliance into water or other liquids.
• Never look directly into the barrel of the hairdryer when it
is switched on.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged, or if the
appliance has been dropped. In the event of damage,
contact the Conair Customer Care Line (refer to ‘UK After
Sales Service’ section for further information).
• Do not use the appliance if the lead is damaged. In the
event of damage, discontinue use immediately. Return
the appliance to the Conair Service Centre (refer to ‘UK
After Sales Service’ section for further information).
• Do not leave the appliance unattended when switched on or
plugged in.
• This appliance is equipped with a safety thermostat. In
the event of overheating, the appliance will run hot and
cold intermittently. In the event of this happening, turn
the dryer off, unplug from the mains and allow to cool
for 15 minutes. Before using again, ensure the rear filter
is clear of hair and other debris. Plug in and switch on.
If the appliance continues to overheat (i.e. element glows
red intermittently), discontinue use immediately, switch off
and unplug. Contact the Conair Customer Care Line (refer
to UK After Sales Service section for further information).
• Take care that the air vents do not become blocked when
in use. Ensure the rear filter is clear of hair and other
