BaBylissPro BAB8700U, Manual

For a shorter back and sides, with length on the top:

•  Attach the longer comb guide as required for the top of your hair – 

your clipper is supplied with 6 comb guides (grades 1-6). Each comb 

guide is labelled.

•  Switch the clipper to the ‘I-ON’ position and the blades will start to 

move.

•  Hold the clipper to the front of your hair with the teeth pointing  

towards the back of your head and move the clipper towards your 

crown. Repeat as necessary, moving in rows from the front and the 

sides of your head to the back.

•  If you then wish to take the back and sides of your hair to a shorter 

length, switch off the appliance and attach a shorter comb guide.

•  Starting at the nape of the neck, with the comb guide flat against 

the head, move the clipper upwards and outwards over the area you 

want to take shorter.

•  Repeat on the sides of the hair, starting with the teeth of the clipper 

pointing upwards and comb guide flat against the area above the ear, 

again moving the clipper upwards and outwards.

Outlining:

•  To tidy up the edges around your cut e.g. neckline and sideburns, 

detach the comb guides.

•  Hold the appliance upside down, so the front of the clipper is facing 

towards your head.

•  Hold the clipper straight on your sideburns or neckline and move the 

clipper downwards. This will give you a clean, smooth finish.

Cleaning & Maintenance

•  To maintain optimum performance, the appliance should be cleaned 

after each use.

•  Blow away any remaining hair on the blades or use the cleaning 

brush provided.

•  Remove the comb guide. The comb guide can be rinsed under 

running water. Ensure they are dried thoroughly before storage or 

further use.

• Do not disassemble the blades.

• Oil the blades after every use to ensure optimum cutting performance.