STYLING ADVICE
•
Ensure hair is dry and combed through. Divide into sections.
•
Before styling make sure the universal heat glove is worn on the hand which is wrapping
the hair around the barrel.
•
Take a section of hair starting around 2 inches from the scalp.
•
Hold the styler at a slight angle pointing the cool tip downwards.
•
wrap the hair around and down the barrel until you reach the ends of the section. as
you wrap the hair, ensure it is distributed evenly so the entire section is touching the
barrel. Try not to overlap the hair as you wrap.
•
Hold the end of the hair in place for 3-5 seconds depending on your the type, then let
go of the end of the hair section and pull the styler away.
•
repeat as necessary through the remaining sections. Use the heat protection mat to
place your styler on between each section to protect surfaces.
•
only once hair is cool, run your fingers through the hair to break up the waves.
•
after use, press and hold the ‘i/0’ button for 1-2 seconds to switch your styler off and
unplug.
•
allow to cool completely before storing away. For extra protection, wrap the styler in
the heat protection mat.
IMPORTANT!
a universal heat protective glove has been supplied to help protect
the hand from temporary contact with the barrel when wrapping the hair around the
appliance. please note the heat protective glove is only designed to give initial contact
protection. Discomfort will be caused with prolonged contact with the hot surface.
Summary of Contents for Titanium Expression WAVING WAND
Page 1: ...wav i n g WAN D T I T ANI U M E x p r e s s i o n ...
Page 2: ...BAB2871U ...
Page 16: ......
