BabyLove BL620A 2010, Instruction Book

30

31

HOW TO USE

HOW TO USE

D. Place each arm through each shoulder 

strap of the harness. Position the buckle of 
the crotch strap as shown right.

E.  Fit either harness tongue into the Harness 

buckle followed by the other tongue until a 
click is heard. If the second tongue does not 
engage - press the red button and re-insert the 
tongues. Check secure engagement by pulling 
harness straps.

         CAUTION: 

The end of the harness adjustment strap is 
connected to the cover to avoid tripping over 
the end. Ensure the harness adjustment strap 
hook is attached when carrying the carrier 
(see page 31).

Click

Tongue

Buckle

F. Ensure slack is removed from the lap straps by 

pulling the shoulder harness straps through the 
buckle tongues, then pull the Harness Adjustment 
Strap to take up the slack in the harness, 

adjusting to a firm but comfortable fit. Make sure 

that the baby’s arms and legs are free and the 
crotch strap is between the legs. Check that the 
slack in straps is minimal. 

    Do not use the restraint if straps do not tighten 

and contact your local authorised service agent 
for repair.

Attach the press stud at the 
end of the strap to the cover to 
prevent tripping over the strap.

Pull Harness Straps 
through the buckle in 
direction of arrows

Pull Harness Adjustment 
Strap to remove slack.

The end of the harness is connected to the cover to avoid tripping on the end. 
Ensure the Harness adjustment strap hook is attached when carrying the carrier 
(see above).

CAUTION: A LOOSE HARNESS IS DANGEROUS

         IMPORTANT:

Do not place the Baby Carrier on a table, bed or a work-top, where it could fall off or 

be knocked on to the floor.