CARE AND MAINTENANCE
CARE AND MAINTENANCE
TO REPLACE THE COVER
A. Place the cover over the Carrier.
B. Feed the shoulder harness straps through
lap strap slots in cover. Ensure that there
are no twists in all straps at the back of the
Carrier.
C. Feed the crotch buckle as well as the
harness adjuster strap through the slots in
the cover.
D. Fully fit the cover ensuring all slots in the
cover line up with the slots in the carrier. Fit
the Padded Insert if required.
E. Feed the shoulder harness straps through
the shoulder strap slots in cover and then
in through the Carrier. If you forget which
shoulder strap slots were used refer to page
19 for correct shoulder harness position
for your baby. Feed shoulder straps through
the Padded Insert if required. Attach the
shoulder harness straps to the Metal Strap
Connector.
F. Engage shoulder harness tongues and
crotch buckle to ensure there are not twists
in the harness straps. Pull to check harness
is attached.
G. Insert the cover wings on the edge of the
carrier and connect the press studs next to
the stabilising bar on the trim.
Pull elastic cover over Carrier
COVER (style may vary)
The cover has been designed to protect your child when seated in the Carrier. Care
should be taken if children either eat or drink while in the Carrier as some products
may cause damage or marking to the cover.
IMPORTANT:
Do not pull sticky items from covers as the cover may be damaged - soak in water
and gently remove.
The seat cover and accessories must not be replaced with any other than the one
recommended by Nursery Elegance Pty Ltd, because the cover is an integral part
of the child Carrier and how it performs. The child Carrier must not be used without
the cover and the padding provided.
38
39
Shoulder
strap slots
Lap strap
slots
Cover wings
Press Studs
Summary of Contents for BL620A 2010
Page 28: ...54 55 NOTES NOTES ...