BabyLove BL620A 2010, Instruction Book

A. Engage the brakes.

B. Press both buttons on the side of the 

handle. Then continue to rotate the handle 
slightly forwards and then release. Rotate 
the handle up over the canopy. Check the 
handle is locked in the upright position.

C. To release the Carrier from the stroller, 

locate the release lever on the back (head 

end) of the Carrier. Squeeze up and hold 

in to release the retaining locks. Lift the 
Carrier up by the handle and remove from 
the stroller.

46

47

TRAVEL SYSTEM-USE WITH STROLLER

REMOVING THE CARRIER FROM THE STROLLER

INSTALLATION OF CAR ANCHOR FITTING

Consult the vehicle owner’s handbook for location of anchorage fittings or 

anchorage points and the possible use of spacers. Some vehicles may have an 

anchor fitting fitted by the vehicle manufacturer. If anchorage points cannot be found 
refer to car manufacturer or local child restraint fitting station or traffic authority for 

optimum position of anchorage point and the use of spacers.

UPPER ANCHORAGE STRAP

IMPORTANT:

THE ATTACHMENT CLIP COVER MUST ALWAYS BE USED AS IT PREVENTS THE 
RISK OF INCORRECT FITMENT OF THE ATTACHMENT CLIP TO THE ANCHOR 
FITTING. ALWAYS ENSURE THAT THE ATTACHMENT CLIP IS CORRECTLY 
ENGAGED TO THE ANCHOR FITTING AND NOT HOOKED OR FITTED TO ANY 
OTHER OBJECT BEFORE EACH USE OF THE RESTRAINT. THIS IS ESPECIALLY 
IMPORTANT IN VEHICLES SUCH AS STATION WAGONS, VANS, HATCH BACKS 
OR VEHICLES WITHOUT A FIXED PARCEL SHELF, SINCE THE ANCHOR POINT IS 
USUALLY NOT VISIBLE.

IMPORTANT INSTALLATION NOTE:

In some vehicles the anchor fitting in the rear vertical panel can only be installed in 
one way. Please refer to vehicle owner’s handbook or a child restraint fitting station 

for correct method.