6
For Baby & Child Use
Ensure there are no twists in the
shoulder strap and the buckle
tongues face the correct way.
WARNING:
Ensure the
shoulder strap is threaded
through the slot, then under the
bar at the rear of the restraint &
connected to the metal strap
connector.
F
FORWARD FACING
Fit Strap to
connector
Feed Straps BELOW bar
Ensure there are no twists in the
shoulder strap and the buckle
tongues face the correct way.
F
REARWARD FACING
WARNING:
Ensure the
shoulder strap is threaded
through the slot, then over the
top of the bar at the rear of
restraint & connected to the
metal strap connector.
WARNING: Do not use the restraint with harness shoulder straps set at different heights or fed through
mis-matching slots. Ensure harness straps are not twisted and that all straps are secure by pulling each
harness strap.
STEPS IN CHANGING SHOULDER STRAP SLOTS
A. Remove the restraint from vehicle as instructed on page 7.
C
At the rear of the restraint, remove
one of the harness shoulder
s t r a p s f r o m m e t a l S t r a p
Connector by slipping strap
through open slot.
Pull the shoulder strap through
slot.
Insert shoulder strap through
restraint slot which will position
shoulder strap level with or above
the child’s shoulder, shown
above. Ensure that the Shoulder
strap passes through matching
slots in cover and restraint body.
E
D
G. Repeat for other shoulder strap. It is better to change one strap at a time so that the other strap will be a
guide for re-assembly.
Slacken Harness Straps by
pushing Harness Adjuster up,
grasping both shoulder harness
straps and pulling out desired
amount of slack.
OR
Feed straps
OVER bar
Fit Strap to
connector
HOW TO SET-UP
HOW TO SET-UP
Pull Straps
B
Pull Straps
Lift Adjuster Up
