11
The Hygro+ night light function has seven different colours.
Press the night light button
to turn on the night light.
The night light changes colour each time you press the night light button
.
To automatically change colours (rainbow function), press the night light button
for three seconds.
NIGHT LIGHT FUNCTION
HYGRO+ •
Instructions for use
DIFFUSING ESSENTIAL OILS
You can also diffuse essential oils with Hygro+.
Simply place a few drops of essential oil in the cup
(2)
and turn on the vapour function.
ATTENTION:
- Never pour essential oil directly into the water tank or chimney.
- Consult your physician for advice on suitable essential oils depending on your child’s age.
- Keep essential oils out of children’s reach.
- Consult your physician immediately if swallowed.
- Press + /- to select the appropriate hygrometry level.
- Briefly press
auto
: «00:00» is displayed and flashes. Press «+ /-» to set the timer with 30-minute brackets (e.g.: 00:30 / 01 :00 /
01 :30, etc.).
N.B.:
a longer pressure on «+/-» will help you set the timer faster.
- Press
auto
for 3 seconds to enter and activate the new setting.
auto
becomes blue. The current hygrometry level of the room is displayed.
To disable the
auto
setting and go back to manual mode, press «ON/OFF» for 5 seconds.
auto
becomes white again.
Hygro+’’s thermometer function lets you display the temperature in the room in which it is installed.
N.B.:
to switch the temperature unit (°C / °F): press for 3 seconds on «+» and «–» at the same time. The recommended
temperature for your child’s bedroom is between 19 and 21 °C.
THERMOMETER FUNCTION
Should I add hot or boiling water to the tank to improve
vapour production?
No, doing so could permanently damage your humidifier.
Hygro+ produces cold vapour using ultrasounds, so it does not
need hot water. Add cold water or water at room temperature.
Some water is left in the tank. Should I empty it?
Yes. You should change the water regularly to prevent the
formation of mould or the proliferation of bacteria inside the tank.
When you do not plan to use the humidifier for an extended time,
empty any water and let the humidifier air dry before storing.
FREQUENTLY ASKED QUESTIONS
• Follow these cleaning procedures to guarantee proper and
efficient operation. Good maintenance is essential for the
humidifier’s long life and to prevent the proliferation of bacteria
in the water, inside the water tank, or in suspension.
• Always unplug the humidifier before cleaning and wait until the
base has cooled.
• Wipe the humidifier with a soft damp cloth or sponge. Allow it
to air dry. Never immerse the base in water or any other liquid.
• Clean the water tank regularly with a mix of chlorine bleach
and water.
• Rinse with water and allow it to air dry.
• Never use detergents to clean any parts of the humidifier
intended to contain water. A cloud of detergent dissolved in
the water could interfere with vapour production.
• Remove the base regularly. Pour 250 ml of pure white vinegar
into the base. Let it sit for 20 minutes while you clean all the
internal surfaces using a soft brush.
• Gently scrub all parts around the transducer using a soft brush.
Do not press directly on the transducer. Empty the vinegar
solution into the sink. Rinse with clean hot water.
• Never use cleaning agents, solvents or abrasive substances as
they could damage the humidifier and its surfaces.
• Before storing, empty the water tank and any water in the base,
respecting the icon indicating how to pour the water. Ensure all
parts are completely dry, then loosen the plug to prevent the
joint from sticking.
CARE AND PRECAUTIONS FOR USE
Summary of Contents for A047011
