2 |
P a g e
The correct use and maintenance of your cot/bed will ensure it gives long and trouble-free use. Please ensure
everyone use your cot/bed know how to use it. The safety of your child is your responsibility.
•
WARNING: Be aware of the risk of open
fi
res and other sources of strong heat, such as electric bar
fi
res, gas
fi
res, etc. in the near vicinity of the cot.
•
WARNING: Do not use the cot/bed if any part is broken, torn or missing and use only spare parts approved
by Babymore.
•
WARNING: Do not leave anything in the cot or place the cot close to another product which could provide a
foothold or present a danger of su
ff
oca on or strangula on, e.g. strings, blind/curtain cords, etc.
•
WARNING: Do not use more than one ma ress in the cot.
•
WARNING: When converted to a child’s bed, do not place this bed near heat sources, windows and other
furniture.
•
The lowest base posi on is the safest. Once your child is old enough to sit up unaided the base should be
used in the lowest posi on only.
•
If your leave the child una ended in the cot, always make sure that the movable side is closed
•
The thickness of the ma ress chosen shall be such that the internal height (surface of the ma ress to the
upper edge of the cot frame) is at least 500mm in the lowest posi on of the bed base and at least 200mm in
the highest posi on of the bed base.
•
The line engraved on the cot end indicates the maximum thickness of a ma ress that can be used with this
cot when the bed base is in the top posi on.
•
We recommend the use of a
minimum size of
for this cot. With a thickness not
exceeding 10cm. The length and width
shall be such that the gap between the
and the
sides and ends does not exceed 30mm.
•
Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed should not be placed
too close to other furniture or windows, and should be placed either ht to any wall or have a gap of
300mm between the wall and the side of the bed.
•
Please ensure that all assembly
ngs always be htened properly before use. And
ngs should be
checked regularly and htened as necessary.
•
The cot is only ready for use, when the locking mechanism(s) are engaged, check the mechanism(s) is fully
engaged before use.
•
Your cot/bed may be cleaned with a damp cloth. Never use bleach or harsh abrasives.
•
To prevent injury from falls, once the child is able to climb out of the cot, the cot should no longer be used
for that child.
•
This cot bed is intended for children aged from birth to 4 years approximately.
•
The cot conforms to EN 716-1/2:2008 + A1:2013. When converted to bed, it conforms to BS 8509:2008 +
A1:2011.
