41
42
7.0
INSTALLATION
7.0
INSTALLATION
7.2 Installation of the Safety Seat / Vehicle
Belt Installation of Base:
WARNING:
Toys or other objects
attached to carry handle can cause injury in a crash. Never
attach toys or other objects to handle when in vehicle.
1. Remove any toy or other objects attached
to carry handle before installing car seat
in vehicle.
2. Remove the Safety Seat from the base
by squeezing the release handle located
at the head end of the Car Seat and lifting
upward on the Car Seat
(See Fig. 24-1).
Store both LATCH
connectors as shown in Fig. 41-1.
3. If you are using the Base with the Safety
Seat, place the Base in the rear-facing
position in a forward facing vehicle
seat as shown in (Fig. 41-2). If you are
using the Safety Seat without the Base,
place the Safety Seat in a rear-facing
position in a forward facing vehicle seat
as shown in (Fig. 42-1).
The Child must
face the rear of the vehicle and Safety
Seat must be placed in a vehicle seat
that faces forward.
Fig. 41-2
Fig. 41-1
Lap/Shoulder Belt
Lap Belt only
4. See Fig. 41-2 for the proper threading of
the vehicle belt through the Base and Fig.
42-1 for the proper threading of the belt
through the Safety Seat without the Base.
5. Buckle the seat belt being careful that the
seat belt is not twisted and is securely
latched into the appropriate buckle, and
not the adjacent buckle (Fig. 42-2).
6. Proper installation of the Safety Seat
or Base requires that the seat belt be
very tight. To tighten the seat belt, push
down hard with your knee or hand on the
Safety Seat or Base while pulling and
tightening the seat belt.
Check that there
is no slack in the seat belt on either side
of the Safety Seat or Base, or anywhere
along the path of the belt, and that the
seat belt is tight from end to end
(Fig. 42-3 and 42-4).
Fig. 42-2
Fig. 42-3
Fig. 42-4
Fig. 42-1
Lap/Shoulder Belt
Lap Belt only
Summary of Contents for CS79C59A
Page 34: ...65 66...
