BABYTREND CS79C59A, Owner'S Manual

56

9.0

 ADD’L INFORMATION

55

8.0

 Final Checks

FINAL SAFETY CHECKS

1. If your child is already in the Safety Seat, check that the 

harness is properly fitted and tight as instructed in the section 

6.1, 

Securing your Child in the Safety Seat / Carrier

.

2. Make sure that the Safety Seat is tightly installed and secure 

in the vehicle by performing the following test every time you 

use the Safety Seat. Firmly push down and side to side on 

the head end of the Safety Seat to make sure that the vehicle 

seat belt does not loosen at all and that the vehicle seat belt is 

fastened very tightly around the Safety Seat / Base. If you find 

that the vehicle seat belt loosens or that the seat easily moves 

or rotates downward, please see section entitled Selecting the 

Best Location for the Safety Seat to determine if the position 

you have selected is adequate and check that you have 

completed all of the steps in the section entitled Securing the 

Safety Seat or Base in the Vehicle. 

DO NOT

 use this seating location if the Safety Seat does not 

remain tightly installed in the vehicle seat!

3. Remove any toys or other objects attached to carry handle 
4. Adjust carry handle into desired adjustment position. 

ADDITIONAL INFORMATION

9.1  Using the Safety Seat in an Airplane

This Safety Seat may be used without the Base in an airplane in 

the same manner as it is used in an automobile. Please check 

with the airline in advance to determine their policies regarding 

the use of Safety Seats aboard the airplane. The Safety Seat 

must be used in only a forward facing airplane seat. Please ask 

the flight attendant for assistance in placement of the Safety 

Seat. Please follow these instructions for proper installation and 

perform the Final Safety Check as instructed herein.

9.2  Using your Baby Trend Safety Seat with a Baby 

Trend Stroller

Please see the stroller owner’s manual for information on the use 

of the Safety Seat with the Baby Trend stroller.

9.3  Cleaning and Maintenance

The hard surfaces of the Safety Seat, (plastic components and 

metal parts) may be cleaned by wiping with a solution of water 

with mild soap. 

DO NOT

 use bleach as it may weaken plastic 

components. Dry all surfaces with a clean towel.

The Harness Straps may be spot cleaned with a solution of mild 

soap and water or may be replaced if they become overly soiled.  

DO NOT

 launder the straps as they may become damaged or 

weakened. Please contact Baby Trend customer service to order 

replacement harness straps.