BABYTREND EZ-Lift 35 PLUS, Owner'S Manual

38

7.0 

INSTALLATION

37

5.0

INFANT RESTRAINT

• From the front of the Safety Seat, pull outward on the Harness 

Adjuster Strap to tighten the Harness Straps. Make sure that 

both Harness Straps are flat and snug on your child’s shoulders. 

A snug strap should not allow any slack. It lies in a relatively 

straight line without sagging. It does not press on the child’s flesh 

or push the child’s body into an unnatural position.

• Fasten the Harness Chest Clips together. Position the Harness 

Chest Clip, by sliding the Clip either up or down on the Harness 

Straps, so that it is level with the child’s armpits.  

Accessory products for use with the Safety Seat are acceptable 

for use provided that they do not interfere with the harness 

assembly, or the proper adjustment of the harness such that it 

remains tight on the child’s shoulders at all times. 

6.2 For the 5-Point Harness

• Put the two buckle tongues together, overlaying 

the left buckle tongue onto the right buckle 

tongue, and insert the two joined buckle tongues 

into the harness buckle on the crotch strap 

(Fig. 37-1). Fasten the Harness Chest Clips 

together. Position the Harness Chest Clip, by 

sliding the Clip either up or down on the Harness 

Straps, so that it is level with the child’s armpits 

(Fig. 37-2). Make sure that you hear the tongues 

click into the buckle and check that both are 

firmly latched by pulling upward on the straps. If 

the harness straps are not securely buckled, the 

safety seat will 

NOT

 provide protection for your 

child. 

DO NOT 

use the safety seat, even as a 

carrier, if the harness does not securely buckle. 

Please call Baby Trend at 1-800-328-7363 for 

assistance. 

Thick, soft, or other compressible material in excess of 1/4 inch 

thick should not be placed behind or under the child or between 

the child and harness straps.

 Examples of accessory products 

are head support pillows or rolled blankets to add additional head 

support.

WARNING: 

Toys or other objects attached 

to carry handle can cause injury in a crash. Never attach toys or 

other objects to handle when in vehicle. 

SECURING THE SAFETY SEAT OR BASE 

IN THE VEHICLE

Please read carefully section 4.3, 

Check that the Vehicle Seat 

Belt is Safe to Use

, before proceeding with the installation of 

the Safety Seat. Please understand that due to the extremely 

large number of vehicles in use today, and the correspondingly 

large number of safety belt systems, this section can only provide 

guidance, as to the proper installation of the Safety Seat, that 

must be combined with the information provided by your vehicle 

manufacturer in order to obtain a proper and safe installation.

Failure to properly install and secure the Safety Seat in a rear 

facing position within the vehicle increases the child’s risk of 

death or serious injury in the event of a sharp turn, sudden stop 

or crash. Carefully follow these instructions, and the instructions 

provided by your vehicle manufacturer for the installation of child 

safety seats, to ensure that the Safety Seat is properly located, 

positioned and held tightly installed at all times.

WARNING

Fig. 37-1

Fig. 37-2