13
14
OPERATION
OPERATION
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
TO FOLD HIGH CHAIR
The High Chair may be folded with the seat in any
of the height positions.
14)
• Place seat in the desired height position.
Place Seat Back in the most upright position
(Fig. 14).
15)
• Squeeze the tray release handle and slide the
tray out (Fig. 15).
16)
• Hang the tray on the hooks located on the
back of the rear leg (Fig. 16).
17)
• Pull upward on the release levers (located on
the sides of the frame) and push the rear legs
in the direction of the front legs until folded
(Fig. 17). Chair is now ready to put away.
DO NOT
allow your child to play around a
folded high chair as it may fall.
TO UNFOLD HIGH CHAIR
Read the Warning and see (Fig. 17), then Reverse
the steps above.
WARNING:
Do not sit
on the frame when the seat
is not attached. Do not use
frame as a foot stool. Potential
pinch point when opening the
frame.
Fig. 14
Fig. 16
Tray Release located underneath tray
Fig. 17
Fig. 15
TO REATTACH SEAT PAD
NOTE:
Certain High Chair models are packaged with
the High Chair Seat Pad and Seat Insert already
attached to the Seat Back.
18)
• Thread non-buckle end of Harness Straps
called Harness Attachment Tabs through
the provided slots in the Seat Fabric, Seat
Insert, Seat Back, and Seat Base (Fig. 18).
When Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure that
the straps are firmly in place.
19)
• Loop the flap on the back of the pad over
the top of the Seat Back. Connect the Seat
Pad to the Seat Back with the two Elastic
Loops. These fit over the Attachment Tabs
located near the top harness slots (Fig. 19).
20)
• Attach the bottom of Seat Pad to the Seat
Base with the two Elastic loops located at
the rear of the bottom of the Seat Pad.
These fit over the Attachment Tabs located
on the Seat Base near where the Seat Back
and Seat Base Join (Fig. 20a).
• Attach each anchor hook of the Seat Pad to
the side of the seat armrest (Fig. 20b).
• Ensure that the slot of the anchor hook
slides through the under side
division (Fig. 20c).
Fig. 18
Fig. 19
Fig. 20a
DO NOT place
