63
64
8.0
Booster Car Seat (Without Built-in
Harness) Installation and Use
8.0
Booster Car Seat (Without Built-in
Harness) Installation and Use
7. Pull the vehicle lap/shoulder belt across
front of child and buckle vehicle seat belt.
- Vehicle shoulder belt on buckle side
must be under armrest.
8. Place vehicle shoulder belt in Vehicle
Shoulder Belt Positioner and adjust
to position shoulder belt on child.
- Thread harness strap through
Vehicle Shoulder Strap
Positioner as shown.
- Pull up or down on the
webbing adjuster until the
vehicle shoulder belt is
centered over the child’s
shoulder.
- Check to be sure vehicle shoulder
belt is properly positioned over
shoulder and snug against child.
NOTE:
Some vehicle shoulder belts with emergency locking
retractors allow child to pull belt out and change position of
belt. Use of shoulder belt positioner helps maintain proper
position of shoulder belt.
2. Tuck harness adjustment belt up under front
of the seat base.
3. Assemble Vehicle Shoulder Belt Positioner
to back of Car Seat (see “Assembly and
Removal of Vehicle Shoulder Belt Positioner”
section).
4. Place the car seat on the vehicle seat in a location equipped
with a Lap/Shoulder Belt and centered between the Lap/
Shoulder belt anchorages (see “Selecting a Vehicle Seating
Locations” section).
Do not place the Backless Booster
Car Seat in a seating position that
has only a vehicle lap belt.
5. If the vehicle seat back is adjustable, adjust
into the upright position or the position
specified in the vehicle owner’s manual
for use with a car seat.
6. Place child in Backless Booster Car Seat
with child’s back and rump contacting
seating surfaces.
WARNING
WARNING
Summary of Contents for HYBRID
Page 50: ...97 98 NOTES...
