19
20
ASSEMBLY
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
ASSEMBLY
TO USE THE CHANGING TABLE RESTRAINT
SYSTEM
19)
• Place child on the changing table, make sure
hands and arms are clear of the restraint. Bring
the restraint around the child’s waist and clip the
male and female ends of the buckle together
(Fig. 19a).
• Tighten strap until it fits snug around the child’s
waist (Fig. 19b).
DO NOT OVERTIGHTEN.
• To remove, unsnap the buckle.
ATTENTION: NEVER
use changing table if it is
damaged or broken.
PARENT ORGANIZER ASSEMBLY
Fig. 19a
Fig. 19b
Fig. 20a
Fig. 20b
TO REMOVE THE CHANGING TABLE
20)
• Flip Changing Table to the outside of the Playard. Unsnap fabric flap of the Changing
Table from Playard. Twist Connector Knobs clockwise to unlock (Fig. 20a).
• Remove Changing Table from the Playard (Fig. 20b) and disconnect the Short Bars
from the Curved Bar by pressing on the snap buttons and pulling apart. Remove
Curved Bar from the Changing Table sleeve.
Parent Organizer
WARNING:
Storage
basket only. Do not
overload. max. weight: 3 lb.
(1.36 kg). (3 lb).
21)
•
Parent Organizer: Position each hook so that
the hooked end is facing the rear side of the
organizer. Press the hook down firmly into
the slot until it snaps into place (Fig. 21a).
• Connect the parent organizer to the playard
by pressing the two (2) connecting clips over
the top rail of one of the playard's longer
sides (Fig. 21b).
NOTE:
When using the full-
size bassinet, clip the parent organizer clips
directly onto the large full-size bassinet clips.
Fig. 21a
Fig. 21b
