7
8
ASSEMBLY
ASSEMBLY
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Playard
Mattress
ATTENTION:
Playard must be fully assembled and securely locked before installing or using
other accessories.
IMPORTANT:
Test each top rail by pushing
down slightly to confirm each is rigid and
securely in place before use (Fig. 3b).
4)
• Place the Playard mattress with the padded
side facing up (Fig. 4).
5)
• Underneath the mattress Insert the hook &
loop through the sloted floor of the playard
(Fig. 5a). Fasten the hook and loop to the
underside of the playard floor (Fig. 5b).
IMPORTANT:
The handle located in the
center of the Playard floor MUST remain
raised (Approx. 45.7 cm or 18 inches) while
locking the side rails in place. If the center is
not raised the rails will
NOT
lock.
If you experience difficulty and one side of
the rail will lock but the other side will not
then, unlock the rail by squeezing the release
in the center and try again. If you still have
difficulty, contact our Customer Service
Center at 1-800-328-7363 or visit us online at
www.babytrend.com.
Fig. 1
Fig. 2
TO ASSEMBLE PLAYARD
Fig. 3a
Fig. 3b
Fig. 4
1)
• Unzip bag and remove playard frame (Fig. 1).
Unfasten straps and set the mattress aside.
DO NOT
push center down yet.
2)
• Top rails must be fully locked before lowering
center. Pull up one rail at a time, hold one hand
on each side of the rail and pull up sharply, do
not pull from the middle where the center latch
release is located, make sure both tubes latch in
place and each rail is rigid (Fig. 2).
IMPORTANT:
The center must be raised while
locking the rails. If one rail will lock but the
other side will not then, unlock the rail by
squeezing the release in the center and try
again.
3)
• Once all four (4) top rails are locked in place,
push down on the center handle (Fig. 3a). The
center mechanism automatically locks in place.
Fig. 5a
Fig. 5b
