11
12
OPERATION
OPERATION
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
TO FOLD HIGH CHAIR
The High Chair may be folded with the seat in
any of the height positions.
14)
• Place seat in the desired height position.
Place Seat Back in the most upright
position (Fig. 14).
15)
• Squeeze the tray release handle and
slide the tray out (Fig. 15).
16)
• Hang the tray on the hooks located on
the back of the rear leg (Fig. 16).
17)
• Pull upward on the release levers
(located on the sides of the frame) and
push the rear legs in the direction of the
front legs until folded (Fig. 17). Chair is
now ready to put away.
DO NOT
allow your child to play around a
folded high chair as it may fall.
TO UNFOLD HIGH CHAIR
Read the Warning and see (Fig. 17), then
Reverse the steps above.
WARNING:
Do not sit
on the frame when the seat is
not attached. Do not use frame
as a foot stoo
l. Potential pinch
point when opening the frame.
Fig. 14
Fig. 16
Tray Release located underneath tray
Fig. 17
Fig. 15
DO NOT place
fingers here.
TO REATTACH SEAT PAD
NOTE:
Certain High Chair models are
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
18)
• Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Insert, Seat
Back, and Seat Base (Fig. 18). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are firmly in place.
19)
• Loop the flap on the back of the pad
over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the
two Elastic Loops. These fit over the
Attachment Tabs located near the top
harness slots (Fig. 19).
20)
• Attach the bottom of Seat Pad to the
Seat Base with the two Elastic loops
located at the rear of the bottom of the
Seat Pad. These fit over the Attachment
Tabs located on the Seat Base near
where the Seat Back and Seat Base
Join (Fig. 20a).
Fig. 18
Fig. 19
Fig. 20a
