BABYTREND TS53A, Instruction Manual

7

 Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

ASSEMBLY

 Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

8

ASSEMBLY

ATTATCHING THE SEAT

• 

ONLY

 approved 

Snap Tech

TM

 products can be 

used on the frame.

4)

• Make sure the seat fabric is properly 

attached to the seat support bar. If the 

seat fabric is unzipped, wrap the seat 

fabric around the seat support bar (Fig. 

4a) and zip the fabric closed. 

• Attach the seat by lining up the seat 

anchors on the side of the seat with the 

anchors on the stroller frame and pushing 

them together until they click securely 

(Fig. 4b). The seat can face in either 

direction, frontward or backward.

TO ADJUST SEAT

5)

• The seat can be adjusted into upright, 

reclined and carriage position. Pull the 

recline button on the rear of the seat and 

rotate the seat into the desired position 

(Fig. 5a).

• 

Upright and Reclined Position:

 There 

are two seat adjusters on the back of 

the stroller seat pad: an upper and lower 

adjuster. Pull tight the upper adjuster 

for upright seating position. Loosen the 

adjuster for a desired recline position. 

Fasten the lower buckle for upright 

position and pull the excess strap through 

the plastic ring and secure in place with 

hook and loop (Fig. 5b).

• 

Carriage Position:

 Make sure the upper 

adjuster is fully loosened and the lower 

buckle is unbuckled to fully extend the 

seat surround (Fig. 5b).

Fig. 4a

Fig. 4b

Fig. 5a

REMOVABLE CANOPY

6)

• 

To attach the Removable Canopy:

Snap the Canopy clips on the inside 

of the Toddler Seat Tubes. Tighten the 

hook and loop strap around the Canopy 

hinge (Fig. 6a).

• 

To open the canopy:

 push forward on 

the front edge of the canopy while holding 

the rear of canopy in place (Fig. 6b).

• 

To fold the canopy:

 pull backwards on 

the front edge (Fig. 6b). 

• 

To use the extended canopy:

 unzip 

the middle of the canopy and pull the 

canopy forward (Fig. 6c).

CUP HOLDER

WARNING:

 To avoid 

burns, never put hot liquids 

in cup holder. Avoid possible 

tipping, do not place more 

than 1 lb. (0.45kg) in cup 

holder.

7)

• To attach cup holder: slide the clip on the 

cupholder over Cup Holder tabs on the 

Handle Bar. Push untill firmly in place 

(Fig. 7).

Fig. 6b

Fig. 6c

Fig. 7

Fig. 6a

Fig. 5b

Hook 

and 

Loop