BAC Document Number: Easybond MKII Manual V03
28/08/13
Page
20
of
32
10. BATTERY CHARGER
PART NUMBER 273 199 5020
Figure 10
The BAC pin brazing battery charger is a 36V 2A, eight-step charge microprocessor controlled
charger, designed to quickly and effectively restore discharged 36V sealed valve regulated lead
acid battery packs. The charger is specially optimised to be used with all BAC pin brazing units.
Light # (figure 10) Colour
Condition
1. Red
Mains On
2. Yellow
Bulk Charge
3. Green
Float / Standby
10.1 SAFETY
This appliance must be earthed and it is for AC input only - see rating label on charger for
details. It is for indoor use only - do not expose to rain or moisture.
Disconnect the AC mains supply before connecting or disconnecting the charger from the
battery.
If the AC power lead is damaged, this appliance should not be used.
If the plug supplied with this appliance is cut from the power supply cord so that another plug
can be fitted, it must be disposed of safely. If such a plug is inserted in a 13A socket outlet the
cut end of the cable would present a shock hazard.
If a 13A non-rewired plug is fitted to this appliance it must be fitted with a three amp (3A)
BS1362 fuse. The fuse cover supplied must be re-fitted if the fuse is changed. If the fuse cover
is lost, the plug must not be used until a replacement is obtained.
Batteries may emit explosive gas mixture - prevent flames and sparks.
Do not attempt to recharge non-rechargeable batteries, they may explode.
