WWW.BALTIMOREAIRCOIL.COM
4
Rigging
Refer to
Table 1
for the minimum recommended vertical dimension “H” from the lifting
device to the spreader bar. The use of a supplemental safety sling may also be required if
the lift circumstances warrant its use, as determined by the rigging contractor.
Model Number
W
(Distance
Between
Lifting
Points)
H (Distance From Lift Point to Lifting Device)
Single
Piece
Lift
Two-Piece Lift
Three-Piece Lift
Lower
Middle & Upper
Lower
Middle
Upper
PFi/PCC-0406
4'
15'
14'
15'
14'
11'
4'-6"
PFi/PCC-0412
4'
15'
16'
15'
16'
11'
4'-6"
PFi/PCC-0709
7'-4"
17'
14'
17'
14'
11'
4'-6"
PFi/PCC-0718
7'-4"
17'
16'
17'
16'
11'
6'-6"
PFi/PCC-1012, PFi/PCC-
1024, and PFi/PCC-2012
10'
19'
16'
19'
16'
11'
6'-6"
PFi/PCC-1212, PFi/PCC-
1224, PFi/PCC-2412 and
PFi/PCC-2424
12'
19'
16'
19'
16'
11'
6'-6"
PFi/PCC-1218, PFi/PCC-
1236, PFi/PCC-2418 and
PFi/PCC-2436
12'
19'
18'
19'
18'
11'
9'
PCC-1220, PCC-1240,
PCC2420 and PCC-2440
12'
19'
18'
19'
18'
13'
9'
The maximum permissible lift point width “W” should be no more than 1’ of listed value.
All standard single cell PFi and PCC products (including models with the optional heavy
gauge coil) are designed to be lifted in one assembled piece as shown in
Figure 1
. A two-
piece lift is shown in
Figures 2 and 3
. All sections, with the exception of the lower section,
require the use of a spreader bar. The distance between the spreader bar lifting points
must be equivalent to the width between the unit lifting ears.
Table 1
. Recommended Vertical Dimension and Spreader Bar Length
PF
i
AND PCC
Unit Rigging & Assembly
2
Figure 1.
Single-Piece Lift
W
H
WARNING:
Failure to use
designated lifting points can result
in a dropped load causing severe
injury, death, and/or property
damage. Lifts must be performed
by qualified riggers following BAC
published Rigging Instructions, and
generally accepted lifting practices.
The use of a supplemental safety
sling may also be required if the
lift circumstances warrant its
use, as determined by the rigging
contractor.
NOTE:
For weight information, refer
to the submittal drawing package.
