Battery Installation
Replace the battery at the start of each irrigation
season and when the low battery symbol
appears. Use a 9V alkaline top quality battery only.
1. Using a Phillips
screwdriver, remove
the 4 battery cover screws.
2. Remove the battery
cover and seal.
3. Replace the battery.
4. After reattaching the seal, put
the cover back, and secure
with the 4 screws.
screws
seal
battery
cover
When replacing seal,
push seal tabs into slots.
Troubleshooting
PROBLEM
CAUSE
SOLUTION
Service Information
Baccara products are guaranteed to be free from
defects in material and workmanship for a period of
one year from the date of delivery.
This guarantee does not apply where equipment is
not used and installed strictly in accordance with
Baccara specifications and Users Guide. Neither
does it apply to failures cause by lightning strikes or
damage due to freezing temperatures or mechanical
causes (e.g. lawn mowers).
Baccara is not liable for
indirect, incidental or consequential damage in
connection with the use of equipment.
To receive guarantee benefits, customers should
return defective units along with the receipt of
purchase to the nearest
Baccara distributor.
Baccara reserves the right to alter, modify or redesign
its products, pricing and warranty at all times without
creating any liability for the obsolescence of customer
inventory of such parts or products.
This manufacturer guarantee policy may apply
differently in different countries.
FLOW CHART for G75 - BWM Controller
8
4257200301 (
6
/
20
)
G75 -BWM
Baccara Water Meter
Controller
Baccara Geva Ltd. Kvutzat Geva, 1891500, Israel
T. +972 4 6535 960 | F. +972 4 6531 445
info@baccara-geva.com | www.baccara-geva.com
10
11
The UD shows the water meter’s sensor
(volume per pulse).
100L: for 100 liter / pulse
1_M: for 1 cubic meter / pulse.
10M: for 10 cubic / pulse
100G: for 100 gallon / pulse
1MG: for 1000 gallon / pulse
Volume of water for irrigation
1. Two presses on
MODE (Each press
2 secs). The below display appears:
The 2 right side digits blink (LD).
7
2. Use and to adjust the 2 right digits.
3. Press SET to continue.
4. Use and to adjust the 2 left digits.
5. Press SET to complete the water irrigation
volume and return to Auto Mode.
Irrigation Start Time & Days Select
1. Three presses on
MODE (2 secs. each
press) the below display appears:
2. Use to change to “
d1on”, or to
change to “
d1oF” (day 1 off).
“oF”
blinks
3. Press
SET to continue. If “oF” is selected,
the program continues to the next day.
If “
on” is selected, the below display appears:
4. Use and to adjust the start’s minutes.
5. Press
SET to continue.
6. Use and to adjust start’s hours.
7. Press
SET to continue. UD shows “d2oF”, “oF”
blinks. Repeat steps 2 to 7 to program all days.
8. Press
SET to complete the start time & days
select & return to Auto Mode.
Users Guide
Maintenance
9
Faulty sensor
Replace sensor
Controller in
Save energy mode
Press any key
to activate screen
Mode
Mode
Mode
Auto Mode
Sleep - No display
2sec
Clock & Day
Min
Hour
Mode
Water amount
Mode
Irrigation days and start time
PROGRAMMING
2sec
2sec
Day selec
t
Hour
Min
Day deselect
Start
Time
2 right digits
2 left
digit
s
Day
Repea
t 7 days
valve
valve
®
