Getting Started
Parts Identification
2
5
6
1
Description
The Baccara Water Meter Controller is an
Irrigation Controller that irrigates by volume
of water. Operates a G75 4Ω latch two wires
solenoid.
Display
The LCD display shows:
• Clock time
• Day No.
• Amount of water left during operation.
• Faucet icon displayed while operating.
• Low battery icon appears when battery
needs replacing.
Mechanical
• Operating temperature -10ºC to + 60ºC
• Dust and water tight: IP66
• UV protection
Electrical
• Power supply: DC unit - 9V battery
• Internal memory retains settings when
power supply disconnected.
Controller display
Upper digits
UD
Lower digits
LD
G75
BWM
Controller
Green
Green
Black
Black
Black
Red
G75
Latch
4Ω
Water
Meter
Sensor
Wires connections
“Dryconn” #22 to #12 AWG
1. Strip wires 13 mm.
2. Align frayed strands or conductors.
3. Do not pre-twist. Place stripped wires with
ends even, lead stranded wires slightly.
4. Twist connector onto wires pushing firmly
until hand-tight. DO NOT over torque.
5. Swipe excess sealant in and around
conductors.
DO NOT REUSE.
Operating Modes
• Auto
• Off
• Manual
UD = Upper Digits
LD = Lower Digits
Operating Modes
•
Auto
This mode is the running mode of the
controller.
UD shows Week’s Day.
LD shows Clock.
Whilst in irrigation, the faucet icon will
turn on and the LD shows the amount of
water left to complete the irrigation.
Battery icon will blink when low battery
is detected:
Display will turn
OFF
(blank) two minutes
after no button is pressed (shut off).
Display will turn
on
with pressing any
button.
•
Off
This mode is for
OFF season or to stop
Auto
Mode permanently.
LD shows
OFF.
Display will shut off as in
Auto
Mode.
Press MODE shortly (0.5 sec.) to shift the
controller
Mode
from
Auto
to
OFF or
backwards.
• Manual
1. From Auto Mode press
SET and
together, irrigation starts.
Display shows "Hand" and "Faucet"
icons.
LD shows the amount of water left
to complete the irrigation.
2. When irrigation is completed the
MODE returns to
Auto
.
3. To stop
Manual
press
SET and
together, irrigation will stop and return
to
Auto.
Programmable Setting : Time Adjust (Clock / Day)
Program setting can operate only from Auto
Mode. If during Program Mode no button
has been pressed within 2 minutes, the
Controller returns to Auto Mode.
Time Adjust (clock / day)
1. Press
MODE for 2 seconds until the
below display appears:
2. Use and to adjust minutes.
3. Press
SET to continue.
4. Use and to adjust hours.
5. Press
SET to continue.
Day 1 blinks
6. Below display appears:
7. Select the desired day by using
8. Press
SET
to complete time adjust
and return to
Auto Mode
.
&
1
3
4
