BACnet
®
Protocol Converter Kit
2
5700-9002 Rev 0
2. Items Required
•
Small flat head screwdriver
•
FieldServer ProtoNode Protocol Converter
•
Mounting hardware and tools
•
Appropriate power, network, and ground wires
WARNING:
Failure to comply with these instructions may
void the warranty.
3. Mounting the ProtoNode
Mount the ProtoNode near the GDA-1600 enclosure.
NOTE:
You must supply all necessary mounting hardware for
the ProtoNode.
4. Connecting the Power Supply
The ProtoNode can be powered by 9-30 VDC or 12-24 VAC. The power
cable is inserted into the terminal block connector on the ProtoNode. A
green cable should be used for grounding. Connections are illustrated in
the photo and chart below.
\
Figure 2. Power Connections
