Instruction 0024-9395
12
Fyrite Pro
3.5 Setup Mode
The analyzer is preset at the factory for the parameters shown below, but
can be changed as described in their associated sec tions.
Function Parameter
To
Change
Fuel
Natural Gas (F1)
Section 4.13.5
Temperature Unit
°F
Section 3.5.2
CO Channel
Auto Zero (A2)
Section 3.5.3
Draft (Pressure)
WC
Section 3.5.4
Clock
Not Initialized
Section 3.5.5 thru 3.5.7
Printer Protocol
IrDA
Section 3.5.8
3.5.1 Entering Setup
1. With the analyzer turned OFF, press and hold down the
HOLD
button.
2. Press the
I/O
button.
3. Release both buttons.
4. The analyzer is now in its Setup Mode. Refer to Sec tions 3.5.2 thru
3.5.8 for information on how to set up each analyzer parameter.
3.5.2 Selecting Temperature Units
The Temperature Setup Screen is labeled “Unit.”
1. Enter the Setup Mode per Section 3.5.1. If necessary, repeatedly
press the
EN TER
button until “Unit” is dis played.
2. Press the
▲
or
▼
button until the desired temperature unit (°F or
°C) is displayed.
3. Press
ENTER
to move to the next Setup Screen, or
I/O
to exit setup.
