Introduction
H25-IR PRO Instruction Manual
2
P/N: 3015-5678 Rev 6
IMPORTANT:
The use of the word
IMPORTANT
in this manual calls attention to a procedure, practice,
condition, or the like, which if not correctly performed or adhered to, could result in incorrect performance
of or damage to the equipment and may void the warranty.
NOTE:
The use of the word
NOTE
in this manual provides emphasis of a feature, operation, etc. Notes are
also useful to address potential service calls/issues.
1.3. Safety Precautions
To assure operator safety and the proper use of the leak detector, please read this manual. It provides important information
on the configuration, operation, and maintenance of the leak detector.
WARNING:
This instrument has not been designed to be intrinsically safe for use in areas classified as
hazardous locations. For your safety,
DO NOT
use it in hazardous (classified) locations.
WARNING:
This is NOT a safety device. Some gases which this instrument can detect may be
combustible/flammable. When properly configured, this instrument is designed to alarm at concentrations
that are lower than the explosive limit of the gas. As such, it is the buyer’s responsibility to initiate an
immediate planned response to any gas leaks as soon as they are detected. This equipment should NEVER
be used to measure or sample gases at or above their respective lower explosive limits.
WARNING:
The leak detector must be operated with a connection to a protective ground. Failure to do
poses a potential shock hazard and is also a violation of electrical safety standards applicable to this type of
equipment.
WARNING:
Do not operate this equipment in the presence of flammable liquids, vapors, or aerosols.
Operation of any electrical instrument in such an environment constitutes a safety hazard.
WARNING:
It is imperative that the exhaust port on this instrument be properly vented as described in this
manual. Failure to do so may constitute a safety hazard.
WARNING:
Extreme care should be exercised when accessing the interior of the leak detector. Only
qualified electrical maintenance personnel should make connections and perform adjustments. Always
remove AC power before opening the leak detector’s enclosure.
WARNING:
The protection provided by the leak detector may be impaired if the leak detector is used in a
manner not specified by Bacharach, Inc. Modifications to this leak detector, not expressly approved, will
void the warranty.
WARNING:
Do not continue to use this equipment if there are any symptoms of malfunction or failure. In
the case of such occurrence, de-energize the power supply and contact a qualified repair technician or the
nearest Bacharach Service Center.
WARNING:
This device uses type “F” fuses rated at 1.0 A, 250 VAC. Replace ONLY with Bacharach-approved
fuses (see Spare Parts and Accessories on page 95 for the part number).
Summary of Contents for H25-IR PRO
