D-BA-0000304.14.5
Operating instructions
Device configuration, system description
V05 / September 07, 2010
OI-17
Replacing the CF card
Observe the ESD protection! (
Chapter 2.7, Page OI
Fig. 7: CF card Replacement
Requirements
Replacing the CF card requires a Phillips screwdriver (No. 2).
Procedure:
1. Loosen the screws (3).
2. Turn the protective cover (2) to the side.
3. Pull the card (1) out toward the top.
4. Insert the new card (1) from the top.
Make sure that the two notches are facing toward the outside when inserting
the cards.
5. Slide the card (1) into the slot to the stop.
6. Close the protective cover (2).
7. Tighten the screws (3).