– Page 1 of 2 –
Bachmann Industries, Inc.
1400 East Erie Avenue, Philadelphia, PA 19124 USA
www.bachmanntrains.com
Customer Service Telephone 800-356-3910
EP-5 ELECTRIC LOCOMOTIVE INSTRUCTIONS
Thank you for purchasing a Williams by Bachmann® locomotive. This locomotive has been manufactured to provide
years of use and enjoyment. Please follow the simple instructions below.
This locomotive has been greased and tested before leaving the factory. Before operating, please lightly lubricate the
points shown in the diagram below. Do not over-lubricate and take extra care to avoid getting lubricants on the wheel
surfaces or traction tires.
1.
For the axles and coupler pivot points
Marked A
, we recommend that you lubricate with a small amount of light
oil such as Bachmann E-Z Lube® #99984 Light Gear Oil.
Do not over-lubricate
.
2.
For areas that require electrical flow, such as roller pick-ups
Marked B
, please use Bachmann E-Z Lube®
#99981 Conductive Contact Lube.
Never use any Teflon® based oil on these areas because this type oil has
insulating properties.
3.
For the gears
Marked C
we recommend that you lubricate with a small amount of heavy gear oil such as
Bachmann E-Z Lube® #99983 Heavy Gear Oil.
Do not over-lubricate
.
OPERATION
After unpacking the locomotive, make sure that the uncoupling plunger is in the correct position with the pin inserted in
the knuckle (see figure 1). Failure to do so will allow the uncoupling plunger to contact the center rail and a direct short
will occur when power is applied to the track. We recommend using an AC hobby transformer with maximum voltage
output of 18 VAC and a wattage rating of
at least 90 watts
.
Pantograph Installation
To install the pantograph, align with the four simulated insulators (molded into the body shell) with the corresponding
holes in pantograph and press the pantograph straight down. It should snap firmly in place.
Summary of Contents for Williams EP-5
Page 4: ......
