10
9. After making any necessary adjustments to the alignment of the all parts,
use the hex bolt driver to tighten all bolts. Do not over tighten. Over tightening
may strip bolts.
10. With the help of another person, Attach the table top to the complete base
by using four 1/4"x18 mm bolts and washers as shown in Figure 9. Guide the
bolts through the holes in the side panels, into the pre-drilled holes in the table
top. Do not tighten completely. Carefully place the burner cover protective ring
inside table top.
Figure 9
11. Open the tank door, place the tank in the holder and connect the regulator
as shown in Figure 10. Screw the black handle clock-wise to tighten. Turn the
handle counterclock-wise to remove. The hose must point down. Open the
control door and check that the valve is turned all the way clockwise to the
“OFF” position. Open the tank valve. Apply a solution of soapy water to the
tank-regulator connection and to the valve-hose connection to check for leaks.
If soap bubbles continue to form, the connection has a leak. If a leak is found,
close the tank valve and tighten all connections.
NEVER USE A FLAME TO
CHECK FOR LEAKS.
Figure 10
