WARNING
•
DO NOT climb or walk on the roof for any reason
•
Requires two or more people to assemble safely
•
Check for underground utilities before digging or
driving stakes into the ground.
•
Check carefully for overhead lines and ensure there is
at least 6
'-7"
(2m) clearance from any overhead
electrical
wires.
•
Permanent structures may require a building permit.
As the purchaser and or installer of this product you are
advised to consult local planning, zoning and building
inspection departments for guidance on applicable
building codes and/or zoning requirements.
•
Wood is NOT fl ame retardant and will burn. Grills, fi re pits
and chimineas are a fi re hazard if place too close to your
structure.
•
Wear gloves to avoid injury during installation.
•
During installation, follow all safety warnings provided
with your tools and use safety glasses.
•
Check all nuts and bolts twice monthly during the usage
season and tighten as required.(But not so tight that you
crack the wood) It is particularly important that this
procedure be followed at the beginning of each season.
•
Oil all metallic moving parts monthly during the usage
period.
•
Check all coverings for bolts and sharp edges twice
monthly during usage season to be certain they are in
place. Replace when necessary. It is especially important
to do this at the beginning of each new season.
•
For rusted areas on metallic members such as hinges,
brackets, etc. sand and repaint, using a non lead-based
paint meeting the requirements of Title 16 CRF Part 1303.
•
Inspect wood parts monthly. The grain of the wood
sometimes will lift in the dry season causing splinters to
appear. Light sanding may be necessary to maintain a
safe environment. Treating your Product with protection
(sealant) after sanding will help prevent severe checking/
splitting and other weather damage.
•
We have applied a waterborne translucent stain to your
unit. This is done for color only. Once or twice a year,
depending on your climate conditions, you must apply
some type of protection (sealant) to the wood of your unit.
Prior to the application of sealant, lightly sand any “rough”
spots on your set. Please note this is a requirement of
your warranty.
OWNERS SHALL BE RESPONSIBLE FOR MAINTAINING THE LEGIBILITY OF THE WARNING LABELS
IT IS IMPORTANT TO CHECK AND TIGHTEN ALL HARDWARE AT THE BEGINNING AND DURING
THE SEASON AS THEY MAY LOOSEN DUE TO WOOD EXPANSION AND CONTRACTION.
Owner’s Manual
Safety Warnings and Maintenance Instructions
5
