Fort Assembly
Phase 9
Phase Notes
• Assemble with hardware as shown.
Parts needed:
• (1) H7 - WALL BOARD - W101708
• (2) M5 - WALL BOARD - W101642
• (3) M8 - WALL BOARD - W101643
• (1) N4 - WINDOW TRIM - W101662
• (1) EJ - L BRACKET 34x67 - A100053
Hardware needed:
• (2) BL - SCREW TAPPING 14x3/4 - H100083
• (20) BR - SCREW PFH 8x1-1/8 - H100088
• (4) BP - SCREW PFH 8x1-1/2 - H100086
Step 1: Attach 'H7' Wall
Board & 'M5' Wall Boards
to 'G3' arched fort wall rail
& 'M12' wall board using
Screws 'BP' & 'BR', as
shown.
H7
BP
G3
M5
N4
BR
M5
M8
M5
BP
BL
EJ
H7
M5
M8
H7
M5
BR
BR
Note: It is vital that the fort
be level before and after
each phase of assembly.
To prevent board splitting, you
must pre-drill each board with
a 1/8" drill bit, before attaching.
Note: Do not overtighten screws, overtightening
may cause the screw to stick through the boards
and may cause sharp points. The head of the
screw should NOT sink into the wood for this
phase, it should be flush.
Step 2: Attach 'M8' Wall Board & 'M5' Wall
Boards to 'N4' window trim & 'M12' wall
board using Screws 'BR', as shown.
Step 3: Attach 'EJ' L Bracket Green to 'H7'
wall board & 'M1' floor board using Screws
'BL', as shown.
M1
Note: Due to the changing size of the wood
as a result of moisture content, you may
need to adjust the spacing of your wall slats
1/16" to 1/8" when assembling walls. It would
be best to line up the boards on the wall
before attaching to estimate if a larger or
smaller gap is needed.
