II.
Install hinge
1.
Insert a #10 x 1½” screw through the second hole
(B) in the tube and into the hole on the side of the
cover as shown, and install but do not tighten.
2.
Lift the tube so it is horizontal, and parallel with
the top of the cover. Drill a 1/8” hole (C) into the
side of the cover, through the hole in the tube
3.
Install another #10 x 1½” screw and tighten.
Tighten first screw then drill the two remaining
holes (A, D) into the side of the cover using the
holes in the tube for locating.
4.
Install two more #10 x 1½” screws and tighten.
5.
Repeat this installation on the other side of the cover.
6.
Adjust the position of the cover on the spa to ensure that it is
square, and centered on the spa.
7.
Attach the main assembly to the spa side by sliding assembly
into closed position and raising it until it is horizontal with the
bottom of the spa cover as shown.
8.
Install one #10 x 1½” screw in hole as shown and tighten.
9.
Install five remaining #10 x 1½” screws.
10.
Repeat procedure on opposite side.
III.
heck operation
C
f the lifting arms. Arms are adjusted for standard setting.
View the position o
If your cover pushes the arms inward or outward when closed, you can
1.
To adj
d slide the
2.
nge pin and bearing, and move
e
3.
he safety covers before use.
adjust them using the following procedure:
ust the arms first remove the safety cover, an
cover back so that lifter is fully extended, but do not open the
cover to the upright position.
Loosen and remove the bolt hi
the spacers from the left side of the tube to the right or vice
versa as necessary, in order to straighten the arm. Replace th
bearing, spacers, and bolt hinge pin before attempting to
operate.
Replace t
Page 2
