shopbackyardpro.com
Assembly
| 3
ASSEMBLY
Please see the below assembly instructions to assemble your Backyard Pro Charcoal Grill.
Included Parts:
• 4 legs and casters
• 4 leg pins
• 1 charcoal grill
• 1 grill grate assembly
1. After removing from packaging, first install the legs of the grill by lining up the holes on each leg and the holes on the grill, then
sliding the provided pins through the holes and securing it on the other side.
2. Stand grill upright on the four legs.
3. Take the grill grate and slide into place on the side channels of the grill base.
Warning:
Grill legs and casters must be in a locked position during use.
Lighting Instructions
1. Take the Backyard Pro briquette charcoal chimney starter (sold separately) and place it in the grill after removing the grill grates.
2. Next, load crumpled newspaper into the bottom of the starter.
3. Fill the top chamber with up to 5 lb. of charcoal
.
4. Once filled, use the bottom vent holes to light the paper.
5. After about 20 minutes, your briquettes will be lit and can be poured out evenly into the grill.
Note:
Startup time may differ depending on conditions.
To light grill without chimney starter, first remove the grill grates. Next, pile your briquettes in the middle of the grill. Coat briquettes in
lighter fluid. Recommended amount is approximately 1/4 cup of fluid per pound of charcoal.
Warning:
Using too much lighter fluid can be dangerous and alter food taste. Follow directions provided on the bottle of lighter fluid
to
avoid
injury.
Note:
Always add lighter fluid to charcoal before attempting to light the charcoal. Do not add lighter fluid to open flame.
Finally, about 30 seconds after adding lighter fluid, light charcoal with a match or lighter. Charcoal briquettes will take around 15-20
minutes to fully catch fire. Move briquettes around carefully with grilling tongs to ensure each one catches properly. Once charcoal is
ready, spread out evenly in the grill.
SETUP
