8
ASSEMBLY INSTRUCTIONS
7. Slide two reflector panels (A) together and
assemble the outer rim using one small screw
(LL) and one cap nut (KK). Repeat this step with
the third reflector panel (A). Once completed,
place the center reflector (B) in the middle and
fasten using three M6 screws (AA) and three cap
nuts (KK). Righten all screws tightly.
Remove plastic protective coating on reflector panel (A)
and center reflector (B) before assembling!
WARNING
8. Attach the reflector assembly made in step 7 to
the top of the reflector studs (FF) on the head
assembly (C). Fasten with six flat washers (HH)
and three wing nuts (GG).
9.
Unscrew the four screws that are preassembled
on the head assembly (C). Place the head
assembly (C) into the top of the post (D) by
inserting the regulator (H) into the post (D).
Tightly fasten the previously removed screws
back into the head assembly (C) through the slots
at the top of the post (D).
