55
2
Measure from bottom of trim.
J-Channel
D
OO
R
TR
IM
D
OO
R
TR
IM
DOOR HARDWARE
Roll the door open.
Install track plate (with top screw only) to measurement shown from bottom of door trim.
Pre-drill holes with 3/16" bit.
It may be necessary to adjust the track plate.
Loosen screw and move plate until plate clears
the bottom of J-Channel
(Approx. 1/8" (3,2 mm)
(Fig. A)
.
Install the bottom screw and tighten upper screw.
Adjust both plates for best operation.
NOTE:
1/4" x 1/4" fender washers are included in
hardware kit. If necessary, use these washers
as spacers behind track plates
BEGIN
¸
1
PARTS REQUIRED:
x2
3/16" BIT
(4,8 mm)
1/8"
(3,2 mm)
(Approx.
clearance)
Fig. A
2"
(5,1 cm)
Screws
3-11/16"
(10,2 cm)
3-11/16"
(10,2 cm)
Flush
Flush
Flush to edge
of door trim.
x4
#12 2" (5,1 cm)