11
3/4 x 48 x 96"
(1,9 x 121,9 x 243,8 cm)
PARTS REQUIRED:
Ensure your
fl
oor frame is square by installing one panel and squaring frame.
FLOOR PANELS (NOT INCLUDED)
x1
2" (5,1 cm)
Fig. C
(2) Nails
Flush
Fig. A
Flush
at top
corner
edge.
Fig. B
(2) Nails
x53
Attach the 3/4 x 48 x 96" panel with the rough side up (painted-grid lines
side) with the 48" edge and corner
fl
ush to the
fl
oor frame (Fig A).
Secure panel with two 2" nails in the corners.
Move to the opposite end. Using the long edge of the panel as a lever move the
panel side-to-side until the top corner is
fl
ush to the
fl
oor frame (Fig. B).
Secure panel with two 2" nails in the corners.
2
BEGIN
1
3
4
Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
Check the
fl
oor frame is square by measuring diagonally across the frame corners. If the measurements
are the same, your
fl
oor frame is square. The measurement will be approximately 133-5/16" (Fig. C).
96"
(243,8 cm)
133-5/16"
(338,6 cm)
133-5/16"
(338,6 cm)
92-1/2"
(235 cm)
48"
(121,9 cm)
Flush
12" (30,5 cm) inside panel.
Grid lines UP
3/4"
(1,9 cm)
Approximately
6" (15,2 cm)
edges of panel.
Flush
DOOR
Floor Panels not included
See page 4 for panel sizes
and quantities.
