15
2" (5,1 cm)
PARTS REQUIRED:
3/4"
GAUGE BLOCK
2x3"
GAUGE BLOCK
SIDE WALL PANELS
3/8 x 46-1/8 x 72" (1 x 117,2 x 182,8 cm)
x2
x90
Fig. A
Fig. B
3/4"
(1,9 cm)
3/4"
(1,9 cm)
2 Nails
1-1/2"
(3,8 cm)
Overlap
1-1/2"
(3,8 cm)
Overlap
2 Nails
Place a
46-1/8 x 72"
panel onto wall frame with primed side up as shown.
Locate the panel 1-1/2" above the top plate. Use a
DQ
as a gauge block for
the 1-1/2" top overhang measurement. Use the
GAA
gauge block to mark
the 3/4" side measurement on the wall stud. Secure panel with two 2" nails
in the corners
(Fig. A)
.
3
2
Nail the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Ensure your wall frame is square by installing one panel and squaring frame.
Move to the opposite end. Using the long edge of the panel as a lever, move
the panel side-to-side until you have a 3/4" measurement on the wall stud.
Secure corner with two 2" nails
(Fig. B)
.
For squareness maintain 3/4" and
1-1/2" measurement along panel edge.
BEGIN HERE
6"
(15,2 cm)
Panel
will be
back from
frame
about 1/8"
1-1/2"
(3,8 cm)
3/4"
(1,9 cm)
46-1/8 "
(117,2 cm)
12"
(30,5 cm)
Primed side UP
3/4" Gauge
Block
DQ
2 x 3"
1
BEGIN
GAA
DQ
