DOOR
10
Fig. C
PARTS REQUIRED:
x55
x1
5/8 x 48 x 96"
(1,6 x 121,9 x 243,8 cm)
2" (5,1 cm)
FLOOR PANELS
DOO
R
Grid lines up
12"
(30,2 cm)
6"
(15,2 cm)
Flush
Flush
Flush
(2) Nails
(2) Nails
3/4"
(1,9 cm)
3/4"
(1,9 cm)
150-15/16"
(383,4 cm)
150-15/16"
(383,4 cm)
3/4" GAUGE
BLOCK
Fig. B
Fig. A
Move to the opposite side. Using the long edge of the panel as a lever, move the
panel side-to-side until the top corner is flush to the floor frame
(Fig. B)
.
Secure panel using (2) 2" nails in the corners.
2
BEGIN
1
3
4
Ensure your floor frame is square by installing (1) panel and squaring frame.
Check the floor frame is square by measuring diagonally across the frame corners. If the measurements are the
same your floor frame is square. The measurement will be approximately 150-15/16" (383,4 cm)
(Fig. C)
.
Install a
48" x 96"
panel with the rough side up (painted-grid lines side) and with the 48" edge and corner
flush to the floor frame
(Fig A)
. Use the gauge block to mark the 3/4" measurement on joist.
Secure panel using (2) 2" nails in the corners.
Use a chalk line grid lines to help locate frame. Use the gauge block to mark the 3/4" measurement on joist.
Secure panel using 2" nails 6" apart on edges and 12" apart inside panels.
3/4" GAUGE
BLOCK
GAA
