10
PARTS REQUIRED:
Ensure your foor frame is square by installing one panel and squaring frame.
FLOOR PANELS
2" (5,1 cm)
x55
Flush
44-5/8" x 96"
5/8 x 44-5/8 x 96"
(1,6 x 113,3 x 243,8 cm)
x1
Install all foor panels with the rough side (painted grid lines) facing up.
Move to the opposite side. Using the long edge of the panel as a lever, move the panel side-to-side until the
corner is flush to the floor frame
(Fig. B)
. Use the gauge block to ensure 3/4" on the joist.
Secure panel with (2) 2" nails in the corners.
2
BEGIN
1
3
4
Secure the panel with 2" nails spaced 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to locate joists.
Ensure that the floor frame is square by measuring diagonally across the frame corners. If the measurements
are the same, your floor frame is square. The measurement will be approximately
170-1/4" (432,4 cm)
.
Place the
44-5/8 x 96"
panel with the 48" edge and corner flush to the floor frame
(Fig A)
.
Secure panel with (2) 2" nails in the corners.
3/4" GAUGE
BLOCK
GAA
20-5/8"
(52,4 cm)
3/4" Gauge
Block
For squareness maintain 3/4"
measurement along panel edge.
BEGIN HERE
3/4"
(1,9 cm)
6" (15,2 cm)
12"
(30,5 cm)
Flush
3/4"
(1,9 cm)
Flush
Flush
3/4"
(1,9 cm)
Fig. A
Fig. B
(2)
Nails
(2)
Nails
(2)
Nails
