Pagina 23 di 62
This manual is the property of Bad Bike; any reproduction, even partial, is forbidden.
E
6.2 Entering the basic settings
When the system is off, push the central button
SW
to turn it on.
Once on, within 5 seconds, push the
UP
and
DOWN
buttons simultaneously for at least 3 seconds to allow
the insetrion of the basic settings (the light at the bottom of the LCD display turns on automatically and turns off
when the procedure is completed).
6.3 Entering speed limit
The first parameter to set is the speed limit. The default value is 25 km/h, and can be modified pushing the
UP
or
DOWN
button.
Once reached the speed entered, the engine stops to protect diver’s life.
Push the central button
SW
to skip to the next setting (rim diameter).
6.4 Entering rim diameter
Using the
UP
and
DOWN
buttons, select the right rim diameter to ensure the accuracy of the data (Km or
miles) shown on the display.
Push the central button
SW
to skip to the next setting (Metric or English measuring system).
6.5 Set up the measuring system (metric or English system)
Using the
UP
and
DOWN
buttons, select the desired system (km/h o Mph).
6.6 Exit the basic settings mode
After setting up the aforementioned parameters, push the central button
SW
for 2 seconds to save the settings
and exit the “set-up” mode, going back to the normal operating conditions.
7. MISFUNCTION CODES
01_error: abnormal regulation of the speed signal
02_error: engine power loss
03_error: engine signal anomaly
04_error: Torque sensor anomaly
05_error: engine or control system anomaly
8. VERSION
KT-LCD v2.3 (release 28 July 2012)
