PAGE 10
SERVICE MANUAL
General Information
Lubricate the
rotation faces
with specified
lubricant on
the lubrication
points before
assembling.
Check the
positions and
operation of
installed parts
is in correct
and properly.
Before battery removal make sure to remove the
battery negative (-) cable first. Note - make sure
tools like open-ended
wrenches do not make
contact with the body.
This prevents the
circuit from shorting
and creating spark.
After service is
completed, make sure
all connection points
are secured. Battery
positive (+) cable
should be connected
first. The two
battery posts have
to be greased after
connected the cables.
Make sure that the battery
post caps are placed in
their proper position after
the battery posts have
been serviced.
When separating a
connector, its locker
needs to be unlocked first.
Then, conduct the service
operation.
Do not pull the wires when disconnecting a connector
or wires. Hold the connector body.
Check to see if
the connector
pins are bent or
loose.
Insert the connectors completely. If there are two
locks on two connector sides, make sure the locks are
locked in properly.
Check to see if any
wires are loose.
If the connector is
covered by a
twin connector
boot, then
secure it
properly.
Before
terminal
connection,
check to see
if the boot is cracked or the terminal is loose.
Insert the
terminal
completely.
Summary of Contents for 1500
