PAGE 121
Rear Wheel:
Removal
• Raise the rear
wheels off the
ground by placing
a jack or other
support under the
frame.
• Remove the rear
wheel nuts, and
then remove rear
wheels.
Installation
• Install the rear wheel and tighten the nuts.
• Torque: 30 ft. lbs
Removal
• Remove the brake
caliper bolts and
then remove the
brake caliper.
Installation
• Install the rear
wheel axle nut.
• Install axle shaft
washer and
• tighten the axle nut.
• Torque: 50 ft.lbs
• Install cotter pin.
• Check the brake
from behind the
brake caliper.
• The brake pad must
be replaced with
new lining when
the brake pad wear
limit reaches the
brake disk.
CAUTIoN
• Wheel must be removed before checking brake
lining.
• Park the MTV on
a level ground,
and check if fluid
level is under the
“LOWER” mark.
• Recommended
Brake Fluid: WELL
RUN BRAKE OIL
(DOT 4)
Summary of Contents for 1500
