PAGE 128
SERVICE MANUAL
Electrical System
Inspection on regulator rectifier:
• Remove the seat,
• Disconnect two 3
pin couplers of the
regulator rectifier.
• Inspect the rectifier
coupler & the wire
harness condition.
I
tem
Check Points
Standard Value
Main switch connection
Bl – B
Battery voltage (ON)
Battery connection
Bl – B
Battery voltage
Charging coil
B – B
0.1 ~ 0.5
Ω
• If the readings
measured are not
normal, check parts
in the circuit.
• If the parts are
normal, then
trouble is in the
wiring. If there is
nothing wrong with parts and wiring, replace the
regulator rectifier.
Ignition System:
Ignition circuit diagram
C.D.I unit:
Disconnect connectors of the C.D.I unit.
Check the following connectors as indicated in the
table at the harness side.
Points to Check
Result
Br/Bl - B
Battery Voltage
Bl/Y - G/R
50-170Ω
Primary Circuit
G/R - B
2.9 +/- 10Ω
Terminal-B - with no cap
15.0 +/- 10Ω
Terminal-B - with cap
20.0 +/- 10Ω
Item
Main Switch turn to "on" position
Pulse Generator
Ignition Coil
Secondary Circuit
Inspection of Ignition Coil:
• Disengage the
connector of the
ignition coil and the
spark plug cap.
• Measure the
resistance between
the terminals of the
primary winding.
• Standard resistance: 2.9
Ω
+/- 10%
• Remove the cap from the spark plug and measure
the resistance between the spark plug and the
primary winding.
• Standard resistance:
With no cap: 15.0
Ω
+/-10%
With cap: 20.0 ± 10%K
Ω
Ignition Coil Replacement:
• Loosen the lock bolt and replace the ignition coil if
necessary.
Inspection of Pulse Generator:
• Disconnect the coupler of the pulse generator and
measure the resistance between the terminals of
green/white and blue/yellow.
• Standard resistance:
50~170
Ω
Summary of Contents for 1500
