PAGE 69
Valve clearance adjustment:
• Remove cylinder head cover. (3 bolts)
• Align the line A on the generator rotor with the
index mark B on the crankcase.
• Loosen valve clearance adjustment nuts and bolts
located on valve rocker arm.
• Measure and adjust valve clearance with
feeler gauge.
• After valve clearance has been adjusted to
standard value, hold adjustment bolt and then
tighten the Adjustment nut.
Standard Value:
IN 0.10 ± 0.02 mm
EX 0.15 ± 0.02 mm
• Start the engine and make sure that engine oil
flows onto the cylinder head.
• Stop the engine after confirmed, and then install
the cylinder head cover.
CAUTIoN
• If lubricant does not flow to cylinder head, engine
components will be seriously damaged.
• When checking lubricant flow, run the engine at idle
speed. Do not accelerate engine speed.
Summary of Contents for 1500
