PAGE 9
General Information
If the length of
bolts and screws
for assemblies,
cover plates or
boxes is different
from one another,
be sure they
are correctly
installed. In case
of confusion,
Insert the bolt into the hole to compare its length with
other bolts, if its length out side the hole is the same
with other bolts, it is a correct bolt. Bolts for the same
assembly should have the same length.
Tighten assemblies with different dimension fasteners
as follows: Tighten all the fasteners with fingers,
then work diagonally
from inside toward
outside, important
components should
be tightened 2 to 3
times with appropriate
increments to avoid
warp unless otherwise
indicated. Bolts and
fasteners should be kept clean and dry. Do not apply
oil to the threads.
When oil seal is installed, fill the groove with grease,
install the oil seal
with the name of
the manufacturer
facing outside, and
check the shaft on
which the oil seal is
to be installed for
smoothness and for burrs that may damage the oil
seal.
Remove residues
of the old gasket
or sealant before
reinstallation,
grind with a
grindstone if the
contact surface
has any damage.
The ends of
rubber hoses for
fuel, vacuum, or
coolant should
be pushed as far
as they can go to
their connections
so that there is enough room below the enlarged ends
for tightening the clamps.
Rubber and plastic
boots should be
properly reinstalled
to the original correct
positions as designed.
The tool should be
pressed against two (inner and outer) bearing races
when removing a ball bearing. Damage may result if
the tool is pressed against only one race (either inner
race or outer race). In this case, the bearing should be
replaced. To avoid damaging the bearing, use equal
force on both races.
Both of these examples can result in bearing damage.
Summary of Contents for 1500
