OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
15
Owner’s Manual
OPERATING PROCEDURES
PIN AND SERIAL NUMBER LOCATION
The PIN plate is riveted to the frame below the seat wrap panel.
Two serial number labels, Part A and Part B, and a PIN label are attached to the frame below the truck bed. On some
early model vehicles, these labels are attached to the frame under the cowl on the driver’s side.
Design changes take place on an ongoing basis. In order to obtain correct components for the vehicle, the PIN number,
manufacture date code, serial number, vehicle model manufacture date code, must be available when ordering service
parts.
Improper use of this vehicle could result in severe injury or death. The buggy is a light duty utility
vehicle, NOT an All Terrain Vehicle (ATV).
When driving vehicle, consider the terrain, traffic conditions and the environmental factors which
affect the terrain and the ability to control the vehicle.
Use extra care and reduced speed when driving on poor surfaces, such as loose dirt, wet grass or
gravel.
Maintain a safe speed when driving up or down a hill. Use brake to control speed when traveling
down an incline. A sudden stop or change of direction may result in loss of control.
To prevent loss of control, do not move the direction selector while the vehicle is in motion. Moving
the direction selector will result in a sudden slowing of the vehicle.
Slow down before and during turns. All turns should be made at reduced speed.
Front of Vehicle
PIN Plate
PIN Labe
Serial Number
Part B
Serial Number
Part A
PIN Label
Serial Number
Part A
Serial Number
Part B
Early Model Vehicles
Summary of Contents for 640690-G
Page 1: ...OWNER S MANUAL 640689 G RECOIL iS REVISED FEBRUARY 2016 ISSUED JULY 2014...
Page 8: ...B vi TABLE OF CONTENTS Owner s Manual...
Page 57: ......
Page 58: ......
