993cc Vanguard
This machine has an oil drain hose installed on the engine
to allow for easier oil changes. Bad Boy recommends that
the oil and filter be changed at intervals of 50 usage hours
or yearly, whichever occurs first. The oil capacity is 2
quarts. Bad Boy 10W-30 synthetic blend engine oil is
recommended for maximum protection.
3.1 Changing your engine oil and oil filter
1)
Remove oil fill cap and open
oil drain. Allow oil to
completely drain. (Make
sure
to have an oil pan ready to
capture old
oil and properly
dispose old oil.)
2)
The oil filter is located on the right side of the
engine. Clean area around oil filter. Place a
container under the oil filter to capture any oil
and remove filter. Wipe off mounting surface
and reinstall drain plug. Torque to 10 ft.*lb.
3)
Place new filter in shallow pan with open
end up. Fill with new oil until oil reaches the
bottom of the threads. Allow 2 minutes for
oil to be absorbed by filter material.
4)
Apply a thin film of clean oil to rubber
gasket on new filter
5)
Refer to instructions on oil filter for proper
installation.
6)
Fill crankcase with approximately 2 quarts of
new oil. Level should top of indicator on
dipstick.
7)
Reinstall oil fill/dipstick and tighten securely.
8)
Start engine; check for oil leaks. Stop
Engine; correct oil leaks. Recheck oil level
9)
Dispose of used oil and filter in accordance
with local ordinances.
PAGE
27
Summary of Contents for Outlaw XP 5400
Page 32: ...PAGE 32 ...
Page 59: ...PAGE 59 ...
